The assembly of industrial lighting fixtures in installations placed in steel pipes is performed, screwing the tube into the threaded inlet of the housing. In sealed installations, the ends of the steel pipe are covered with a sealing substance (e.g. crowd), wraps with hemp and screwed into the housing hole. W celu …
Suspending lighting fixtures
Luminaire hanging on a hook attached to the ceiling.
Suspending the luminaires can be done in various ways, depending on the place of installation of the luminaire and its type. The easiest way to hang the luminaire on a hook embedded in the ceiling is shown in the drawing. Sposób ten jest powszechnie …
Installing lighting fixtures
Installing lighting fixtures:
1. Umocowanie oprawy powinno być trwale. The pendant luminaire should be hung on a designated hook. If a pipe is used to attach the luminaire, the pipe must also be used to lay the cables in it.
2. Przewody nie powinny być …
Light fixtures – requirements
Light fixtures – requirements:
1. Oprawy oświetleniowe oświetlenia podstawowego w pomieszczeniach innych niż suche lub na zewnątrz pomieszczeń, placed at a height less than 250 cm from the surface, walked on and powered by a rated voltage higher than 42 V prądu …
Installations made with busbars
Installations made with busbars.
They are used in factory halls in the event of changes in the scope and type of production, necessitating regrouping, replacement or installation of new machines. Stale połączenie maszyn z siecią zasilającą za pomocą kabli lub przewodów ułożonych w rurach utrudnia …
Duct installations in floors
Duct installations in floors.
The cables are distributed in divided channels (tubes) sheet or PVC floor coverings. Workstations are equipped with floor boxes (coffers, audits), in which any set of sockets is mounted. Floor boxes are integrated into the network of channels (tubes) …
Installations made with heating cables
Floor heating: 1 - Wall, 2 - expansion tape, 3 - floor, 4 - concrete screed 3-7 cm, 5 - concrete screed approx. 2 cm, 6 - heating cable, 7 - mounting tape, 8 - Styrofoam 2-5 cm, 9 — …
Installations made with wires in strips or wall channels
Fixing the base of the batten with screws and expansion plugs; 1 - batten cover, 2 - base of the slat, 3 - screw with a countersunk head, 4 - spherical head screw, 5 - expansion plug.
Instalacje wykonywane przewodami w listwach lub kanałach …
Installations made with single-core cables in plastic pipes – embedded in the monolith
Installations made with single-core cables in plastic pipes – embedded in the monolith.
All cans and pipes, to be embedded in the concrete mass, from which the building is erected, powinny być mocowane do deskowania lub do prętów zbrojeniowych przed zalaniem masą …
Flush-mounted installations
Flush-mounted installations.
This type of installation is used primarily in residential and general construction (schools, hospitals, clinics, china, theaters, offices etc.). They are also used in industrial construction in non-production facilities.
Do wykonania instalacji wtynkowych stosuje się przewody wtynkowe wielożylowe …